CocoaDrinker

Hey all, I need a recipe to make good hash oil. Can anyone help me out?

SirSmokesAlot

Take an amount of Marijuana that you would like to make hash oil out of, and cut/chop/grind it to a course or fine powder. (the finer the better, it is waaaay easier with a coffee grinder than a pair of scissors though)

You will need 2 pyrex dishes, one of which needs a lid. A fine mesh screen of some sort, a metal cooking strainer with a fine mesh metal screen is adequate. A metal spoon. For a solvent you can use either 99% Isopropyl Alcohol, Grain Alcohol (Ethanol), Denatured Alcohol (Methyl Alcohol), or Acetone.

**** THESE CHEMICALS ARE VERY FLAMMABLE AND CAN BE EXPLOSIVE! USE WITH CAUTION AND AWAY FROM FLAMES! *****

Place powdered pot in pyrex dish with lid. Pour solvent over the herb and stir well for several minutes until liquid starts to turn green. Place a lid on the dish loosely and let it sit stirring occasionally. You can let it sit as few as 3 hours or as long as a week, the longer you let it sit the stronger it will be. (NOTE: You may need to add solvent periodically if you plan on letting it sit a long time)

After the herb is done soaking, strain the solvent through the mesh screen into the second Pyrex dish. Take the soaked herb from the screen and soak it again to get all of the active substances you can. Take the blow dryer AT A DISTANCE from the green solution in dish 2 to speed the evaporation of the solvent. After a while the solvent will evaporate and you will be left with a sticky green substance. This is the hash oil. Enjoy!

NOTE: IF YOU ARE NOT EXPERIENCED WITH DANGEROUS CHEMICALS DONT DO THIS! PERIOD.

GhostPimp

i don't know how to make hash oil

but that stuff rules fo sho

put some on some papers, sprinkle on some doobage, smoke and enjoy

gets ya ripped!

Shaman

The way I do it is to crush the green material and put it in a blender with some high octane alcohol (I used isopropyl, but it tasted funny... I'd use everclear or something else similar)
Pure Ethyl Alcohol if you can get your hands on some.
Blend it up till its nice and green. Strain it through a couple of coffee filters. Put the green liquid in a pot on the stove, and boil off the alcohol. The brownish blackish goo at the bottom is hash oil.
S T O N E Y

SirSmokesAlot

I used to make my Hash Oil with Ethanol (Grain Alcohol) until I found a way that makes a more potent product. Here's how you do it:

Grind the Marijuana into a fine powder in a Coffee Grinder. Put in Pyrex bowl, and pour Acetone over it. You should have about 2 or 3 times as much Acetone as ground Marijuana. Let this sit for at least 24 hours, but the longer you let it sit the more potent it will be. If you let it sit for more than a day you will need to add a little Acetone now and then to keep it from evaporating away. Pour the contents of the bowl through a fine mesh METAL screen into another Pyrex bowl. Mesh size should be about that of a screen for your bowl. Make sure the screen has NO plastic on it. Press the pulp in the screen to get any remaining liquid. Use a blow dryer to evaporate the Acetone. Near the end do not point the hair dryer on High right at the Hash Oil. This will degrade the THC into less psychoactive substances such as CBD & CBN.

You can also use a heating pad or hot water bottle underneath the bowl to evaporate it if you dont feel like evaporating it with a blow dryer for 30 minutes.

I suggest using a small Pyrex Bowl. This is much easier to work with than a large one.

Here's a trick I discovered... Once you smoke most of the Hash Oil, the bottom of the bowl is covered with a sticky layer of it. Normally it would be wasted because it is very hard to get it off without solvent. Take your lighter and GENTLY heat the bowl. You can also hold the bowl upside down and let the warm air from the lighter slowly warm the sticky oil itself. After a couple minutes of slow heating, it should be more gooey and less solid. Take your rolling papers and press them onto the layer of goo. Rub your fingers on the back of the papers as if you were trying to stick them to the bottom of the bowl permanently. Very carefully remove your papers and repeat in different spots to cover the whole paper. Roll yourself a joint with this sticky dark green paper and you can get a whole room full of people high all night long.

Always store Hash Oil in an Opaque Airtight Container. When THC is made into an extract form such as Hash Oil, it breaks down much more readily than if it were still inside the plant. The best way to store it is in your refrigerator or freezer in a covered Pyrex Bowl which is inside of a Freezer Bag. This will preserve it's potency.

** ACETONE IS VERY FLAMMABLE!! DO NOT ATTEMPT TO HEAT IT ON THE STOVE IN ORDER TO SPEED UP THIS PROCCESS!!!!!!!!! **

Shaman

I wouldn't even want to RISK smoking acetone...

SirSmokesAlot

You dont smoke the Acetone, you smoke THC extract. You also dont smoke Ethanol when you make extract with it. They are solvents and they both evaporate. The chemicals used to make commercially available Hash Oil are generally Petroleum Ether, Acetone, Butane, and more, but not usually Ethanol because it doesnt make as pure of a product.

CocoaDrinker

Potentially stupid question ahead:

Where exactly is acetone aquired. I have always used everclear, but how do i get acetone?

SirSmokesAlot

Nah it's not stupid

You can get it at Wal-Mart or home Depot in the paint section. Make sure you get pure Acetone and not a mix. It should say 100% Pure Acetone. Do not use nail polish remover or any other such thing that contains Acetone, but is not 100%.

Spuds

I'd never smoke anything made from acetone or ethnol (sp) alcohol either ... Yer just asking for trouble there. If not health problems, then turning yerself into a human torch when the acetone blows.

For that, it's not worth it.