Marijuana.com

cherry

it's easy, u just use a bill to roll the joint tighter.

 

glasyalabolas

If you roll a really loose joint you fold a dollar bill over it and use your thumb and forefinger to roll the joint up and down in the crease. It tightens it up quite a bit, but won't salvage the worst of them.

MisterT

To use the dollar bill method you just take any cash, fold it in half widthwise. Then put some bud in the creaseand roll it with your fingers until you feel a tube shaped bunch of weed in the dollar. After that you open the fold enough to slip a paper in there. Put the paper in with the glue side facing you,and then push up on the side of the dollar bill that is facing you with your thumbs and youll see the paper start wrapping around the weed. before it gets all the way around, lick the glue, and then roll it the rest of the way. This way rolls perfectly even, tight joints.

OZONE

Yeah, you can also buy rolling mats which work the same as dollar bills. They are made up of fine, fine, fine pieces of bamboo tied together. Same difference really.

__________________
OZONE

hedburner

Many many years ago my daddy taught me how to roll ciggies using bull durham tobacco, he smoked them not me. When I got older and discovered other herbs I was well practiced and adept at rolling a nice tight reefer. Just takes some practice.

 

DoritosMan

I couldnt roll even a lousy joint, they always came loose and flacid. But now my joints are nice and tight. I'll try now to write how i roll a joint, its pretty easy if you watched me but i'm going to need some serious typing to explain but here we go:

1. Chop your weed and get a rollie.
2. put the weed in the rollie and the glue facing you.
3. With your thumbs roll up and down the side of the rollie that is towards you, this will make the weed spread out and get into a cilyndrical shape, dont worry if you spill after a while you get the hang of it
4. Now that your weed is all spread, get a card (id card, phone card, credit card, even ruler is good). Now tuck the side of the rollie that is towards you, tuck that thing behind the weed. Move the card side ways to tuck the side too.
5. Now that everything is tucked in, with the hand that is holding the joint move your thumb up till you get a the joint to roll on the side of the card.
6. as soon you see the joint is rolled once, take the card out and continue to roll. When the rollie is almost done, like the gum and seal.
----optional----
7. If your joint is kinda of thick (this will happen the 1st times), get a match or a twig and stuff the weed in from the sides.
8. Close sides and enjoy
or
9. If you are like me and yoiu like a joint with a roach (cardboard thing) roll a little piece of paper and shove it in. Ta-da! a nice joint

If i had web cam i'll would make a little movie, im getting in touch with a friend to borow his cam. So wait for the movie "Rolling Joints for Newbies"

__________________
another tasteless and odorless latin american

I pity the fool that dont use the search engine!

glasyalabolas

A while ago I wrote this up on how to roll a nice, fat cone:

1.Get yourself some EZ Wider double wides. None of that Bambu/Zig Zag/ultra thin rolling paper, that is for real cigarettes and little pinners. We're going for a pretty fat joint here.

2.Tear a small (about 1/2" by 1/2") square of cardboard off a pack of cigarettes or the pack of papers.

3.Roll it into a hollow cylinder between your thumb and forefinger. Put it aside. (It will act as a duct opener, allowing for an easy hit, as well as eliminating a really small roach that you can't pass anymore. I hate wasted pot.)

4.Break up your pot really well. No seeds, no stems. Make it into a small pile, using more than you think you need. (You can always put the rest back).

5.Fold the bottom 1/4 of the paper up and crease (not too hard of a crease, though).

6.Hold the paper as such: Tip of forefinger inside the crease, middle finger behind the paper, but right next to your forefinger, thumb underneath the paper, pinching it with your forefinger. You should have an open V shape.

7.Sprinkle your pot in. Make an uneven pile, with the pile being lighter as it gets nearer your fingers.

8.Carefully take the paper by the other side with your fingertips (using your other hand). Be very careful not to tilt the paper and shift the pot.

9.Place the cardboard cylinder in the empty space where your fingers were.

10.Carefully start to roll the joint. Take the paper in between your thumb and forefinger about 3/4" above the cylinder. fold it over and wrap it underneath, bracing the back wall against your ring finger and pinky. Where you are holding it on the other side you should have one finger inside the crease, keeping it open. It should start to take on a conical shape. Be light, and do not try to make the joint very tight, just snug around the cylinder.

11.Lick the corner of the paper w/ the glue and attach once you have formed a nice cone. It will look like a waffle cone, uneven at the top.You can even lick the top of the paper, opposite the glue side, after you have pressed it to the wall of the cone. As long as the paper is saturated there the glue will stick.

12.You should have a fairly stable cone. Turn it so it is facing up, like an ice cream cone.

13.Fill it with pot, intermittently packing it down (lightly) with your pinky. You should be holding the joint in all five fingers at all times with one hand (fingers pointing up and bracing the walls of the cone). Pack and fill with the other hand.

14.When the cone feels full, and is fairly tight, fold over the bits sticking up. You can twist the end into a small, tight spiral, helping pack the cone tighter.*NOTE* You don't need to lick anymore glue, as the cone should hold together by itself.

15.To light, smoke it like a cigar. Puff, spin, puff, spin, That first hit is a doozy, and will really get your head spinning.