Marijuana.com

TokinChick

Hi everyone,

I am loving my 3G, but I want to make sure I'm getting the most out of it.

First, I turn it on full heat and let it heat up for about five minutes. Then I turn it down to about 2 o'clock.

My first few hits are visible, like smoky but not quite smoke. Then sometimes I can get hits that are almost invisible unless you look really close. Which kind of hit is the right kind? Should I be able to see the vapor or should it be invisible?

Also, should I be taking long, steady pulls or short ones? Fast or slow?

Any tips would be appreciated. My unit is the standard, where you have to hold the parts together. (When we first got it we were like, "how does it stay on?" until I looked it up and found out you actually had to hold it there.)

 

sterbo

Sounds like you're on the right track. I suspect you'll start a fresh 'bowl' at the lower end of the recommended range and ratchet it up as you go. Keep in mind that the visability factor can be deceiving.

Seemingly invisible vapor can knock your socks off...

.

__________________

Vicki

I've never turned my Vapor Warez up full blast. I just keep mine set at the 12 o'clock position, and flip the switch on.

The first hits will always be the most dense vapor, and will gradually decrease the longer the contents are vaped. I always just take slow, steady draws at the beginning, and then draw a little harder towards the end, but I've never had to turn up the heat.

I also stir up the herb in the whip a few times during the vaping process. That helps ensure air flow reaches all the pieces of herb.

__________________
Disability is a matter of perception. If you can do just one thing well, you're needed by someone.
- Martina Navratilova
R.O.A.R-Reach Out. Act. Respond.
Are you hungry?
http://www.marijuana.com/culinary/83...s-recipes.html
Want free samples?
http://www.marijuana.com/cool-links/...e-samples.html

TokinChick

Thanks for the tips My last run-through was mostly all invisible vapor but it did the job nicely!