Marijuana.com

zxcvbnm

Everytime I put herb into the bowl, it alwasy breaks up after a bit, and gets sucked into the bong, and gets destroyed in the water, how can I prevent this from happening? Am I sucking too hard? or is there something i'm doing wrong. Tips/advice would be appriciated, oh yeh, i am a newbie.

 

ThE_MinOritY

put a screen in the bowl, problem solved

__________________
Minor drug offenders fill your prisons you don't even flinch. All our taxes paying for your wars against the new non-rich - System Of A Down

zxcvbnm

how can i make a screen?

ThE_MinOritY

well if you really want to make one you could spend hours crafting brass threads into a screen
-OR-
you could go buy some from your local headshop
-OR-
you could use the screen thats under your faucet, those work too but who knows what theyre made out of

your best bet is to just go buy some, you can get like a half dozen for a buck, theyre not expensive at all

b4k3D313

where can u buy packs of screens?

 

ThE_MinOritY

read my above post

sleepischeap

how much do you cut it up? if its too fine that could be why
how hard do you suck? what i like to do is nice slow and steady at the start till it has turned to ash, then i pull it into the water.

if you cant buy a screen and u really need to try making one out of some staples
i did that once. i only screens for resin though cos it melts and just drips throgh.

JohnnyC

I went to home depot and bought one of the little fixtures with the screen that goes under your sink. It had two little round screens which were made of brass and worked perfectly for my needs. I just threw away the little plastic pieces that came with it. It cost like $1.25

derrockg

oh and with screens for faucets always remember to fashion some sort of tongs outta a paper clip or something, hold the screen and burn the chemical water protection **** off of it

cronicredpepsi

if you have regular to cheep faucets they going tobe metal its thebest way to go