Marijuana.com

Fryth

You have to figure out a way to make the bowl cap seal the hole without having to screw it on and then back off again. You'd have to make it out of a plastic wine cap or something.

 

SirSmokesAlot

Great way to make a bowl for a 2 or 3 liter Gravity/Bucket Bong:

Find a metal bowl piece that has threads on it for screwing it in.

Get a soldering iron and carefully make a hole in the plastic botle cap just smaller than the diameter of the screw threads on the bowl.

Screw the bowl into the hole (heh it rhymes!).

If you have trouble screwing the bowl into the hole, heat the edges of the hole slightly with a lighter to make it soft. Then screw in the bowl and viola!

If you have trouble making it airtight, and you dont want to soften hole with a lighter (So you can unscrew the bowl to clean it) Then use some plumbers tape. It is a very thin silicon tape that they sell in hardware stores. Wrap a bit around the threads on the bowl and screw it in. This should make it airtight.

Also, make sure and use lots of ice in your Gravity/Bucket bong!

vitamainTHC

this will knock even a serious pothead out at least for a few minutes warning use with caution.

take a 3 litre bottle cut the bottom of the bottle off at the lowest point possible. now make a bowl attach it to a stem now put that to the side. now go and check all the taps in your house where the water comes out and loook if the gauze is metal (the filter the water comes through) if it is take it out. use that to make a lid. how to make the lid: cut a hole in the 3 litre plastic bottle lid with a hot knife, place the gauze under neith that hole and selotape it there. now place the lid on top of the 3 litre bottle. now make a hole as big as the stem on the second bowl in the 3 litre bottle. place the second bowl in the bottle selotape down and theres the ultimate bucket. make sure after you have pulled the bucket and removed the lid off the 3 litre bucket that you blow the ash off the second lid otherwise when you take the bucket you end up with alot of boulders in your face very painful. have fun.

papichoolo

great idea guys...ill make one today!

CaptainChronic

best 2liter cap bowl i ever made is my glass slide grav bong bowl. stuck a phat handblown glass slide piece thru a drilled hole in the 2liter cap and walla! glass g-bong bowl

 

KzA

melt an inch on hose into the lid and put your bowl (cone) in that no Krazy fumes.